HL7 - Version 2.7.1

A cancellation is a request by the placer for the filler not to do a previously ordered service. Confirmation of the cancellation request is provided by the filler, e.g., a message with an ORC-1-order control value of CR.

Typical

The combined result code provides a mechanism to transmit results that are associated with two or more orders. This situation occurs commonly in radiology reports when the radiologist dictates a single report for two or more exams r

A request by the placer application for the filler application to discontinue a previously requested service. The differentiation between discontinue and cancel is that discontinue effects the order/service and all future occurrence

In response to a Filler application requesting refill authorization (RF), DF indicates that the placer does not authorize refills for the order. ORC-16 Order Control Code reason may be used to indicate the reason for the request den

FU notifies the placer that the filler issued a refill for the order at the patient's request.

There are three circumstances that involve requesting an order number (ORC-2-placer order number or ORC-3-filler order number):

(1) When the filler application needs to request an ORC-3-filler order number from a centralized appli

These order control codes are used to communicate an order between systems where the order is intended for informational purposes. For example, an order that will be performed by a vendor outside the enterprise of communicating syst

The parent (PA) and child (CH) order control codes allow the spawning of "child" orders from a "parent" order without changing the parent (original order). One or more ORC segments with an ORC-1-order control value of PA are followe

See comments for OP - Notification of order for outside dispense.

RF accommodates requests by either the filler or the placer. The filler may be requesting refill authorization from the placer. A placer system may be requesting a refill to be done by the filler system.

Typical response

A replacement is the substitution of one or more orders for one or more previously ordered services.

The replaced orders are treated as though they were canceled. If and when an ordered service can be replaced are local

A replacement is the substitution of one or more orders for one or more previously ordered services. See comment 1 on RO - Replacement Order for further discussion.

The order replace request code permits the order filler to replac

A replacement is the substitution of one or more orders for one or more previously ordered services. See comment 1 on RO - Replacement Order for further discussion.

The unsolicited replacement code permits the filler application t

See comments for NA - Number Assigned.

An unable-to-cancel code is used when the ordered service is at a point that it cannot be canceled by the filler or when local rules prevent cancellation by the filler. The use of this code is dependent on the value of ORC-6-respons

Negative response to RF Refill order/service request, indicating that the receiving application was not able to complete the refill request.